Pole saws are the most useful power tools which are widely used to cut tree branches. But it can be a little more difficult to use and control them than other saws due to their handle length.  

But nothing to be dismayed. It’s not too hard or rocket science that you need to have months of pole saw training. 

On the other hand, if you’re not familiar with pole saws, this guide will help you with everything. Let’s go to the main content to know more.

Rooring PPC Marketing

The Guide To How To Use A Pole Saw

What is Pole Saw?

Pole is one of the most essential garden tools which is basically a saw at the end of a pole. Most importantly, pole saws are operated by different power sources like an electric battery, gas-powered, and petrol. 

There are so many manual pole saws that don’t require any power source. Pole saws are mainly used to cut thin branches of a tree or other normal tasks.     

Select Branches From Lower Height First

First of all, you should decide which one you are going to cut. You must select branches from the lower part of the tree. Identically, it will make an aisle for the higher ones. 

Moreover,  This technique will save you from adjusting your pole usually saw. You also can cut the nearest vines angling from various sides.  

Pole Saw Adjustment

Rooring PPC Marketing

If you would like to cut tree branches, then adjust your pole saw properly.   

Don’t worry, it’s very easy. You just adjust your pole saw to reach the branches on top. 

But, you don’t take much height if you are capable of cutting tree branches by your hands. Owing to the extra height of a pole, it can be too tiresome for you to control the saw. Additionally, you can follow the user manual instructions when adjusting your new pole saw.  

Start Slowly From The Bottom

It is one of the most important techniques when you are planning to cut the tree branches. Unfortunately, most people start cutting tree branches from the middle of the top branches. 

Rooring PPC Marketing

But in our suggestion, you should try the “V” cut. In general, You can start cutting from the bark layer until your saw reaches into the wood.   

Further, you should cut from underneath of the vines when you go for jump cuts. 

Therefore, your pole saw should be at the correct angle to cut on the branch from the top. We basically recommend you to cut tree branches slowly. It can be the best practice for cutting tree branches.  

Start Cutting The Branches 

Always take a gap when you are cutting the tree branches by using a pole saw. Cutting with a pole saw that can give you a kickback. So be careful about handling it. 

On the contrary, some people ask me, how to cut broken tree branches? Get relaxed, you just apply the same technique. But if you want to change the cutting height of the saw, then you can take help from an expert. 

Finish Your Work

For easy transportation, you need to cut the fallen branches into small cuts. Keep in mind, you never leave them in the ground. Moreover, you should clean the area where you will use it later.   

Final Verdict:

Thanks for reading the whole article. I think you have found a complete guide about how to use a pole saw. It is not too difficult a task. So anyone can use a pole saw with a little bit of practice. 

However, it can be a difficult task for very beginners. Hopefully, this guideline will help you to implement your dream of using the pole saw. Equally, you will be able to cut your tree branches smoothly.  


As a civil engineer and roofer, I love to share the experience that I have gained through the last couple of years. In the roofing industry, practical experience is a very crucial fact that can help you a lot. Hence, I want to help you with my blog.

Write A Comment